Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in 3D Printers
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on 3D Printers
This was my first 3d printer. I thought it was pretty easy to build, although the instructions were not great. The wiring is also very messy, but easy, just plug and play. One of the first things i printed was a belt tensioner because the belts are very hard to keep tight. But once you start to get into it and learn a little more and get the settings adjusted correctly then it puts out quality prints and it was fun to learn and use.
Verified purchase: Yes | Condition: New
20A power supply not up to power requirements of heated bed, extruder heater, stepping motors and processor. Upgraded to 30A to get to work properly. Had to add power switch to turn on and off versus plugging in and unplugging power supply. Overall quality ok. Poor documentation. Would not recommend for users without electrical experience.
Verified purchase: No
Great printer to start out, the instructions are not the best but adequate. Takes 6-8ish hours to put together, not difficult just alot of parts takes some time. The system printed great from the get go, and still does 6+ mos later,
Verified purchase: No