 |
I cut thru a hard hard steel bed rail in a flash This is the first time I have used a plasma cutter but it only took a few cuts and I was on my way. Not an expert yet but I'll get there, I've got time, I am only 85
Verified purchase: Yes | Condition: New
the cutter works but it comes with no instructions. once you figure out how to hook it up then the next problem is there are no operational instructions, nothing about what pressures you have to set the air at just really bad. there are parts included in the box that they make no reference to at all . spend a few more bucks and buy from a company that you know
Verified purchase: Yes | Condition: New
I like mine, The instruction book isn’t very good, if you have questions you need to ask someone or go on YouTube, It Works good if you cut 1/8 but 3/8 is almost too thick, and burns up consumables really quick if you cut thicker than 3/8. If you plan on cutting a lot, I would get a brand name, Miller hobart etc. but there 1500 or 1800 bucks
Verified purchase: Yes | Condition: New
I give it 3 stars for this reason. 1 it's built ok don't drop it or knock it over. 2 the ground clamp and wire a to small and to weak make of thin cheap metal. 3 the torch works good but the consumables don't last long and the high frequency start is all over the place. But all and all it's good for around the house use and small work.
Verified purchase: Yes | Condition: New
Have not used it yet had pacemaker installed and not supposed to use one. But will let you know when I do. Thank you;
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Tables
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Tables
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
