 |
Works great. Maybe a little too good. I had to turn down the power when installed on my 2006 Toyota Sequoia. If I turned it up all the way, I was concerned it might blow the speakers. I turned the volume up on my new double din radio all the way and then adjusted the Axxess controller up and down until I thought the system was as loud as it would ever need to be. Basically setting the top end volume.
Verified purchase: Yes | Condition: New
It was able to wake my JBL amplifier through can bus, but the sound was terrible, the higher frequency (13-17 kHz) got terrible distortion, so the sound very ugly, my ears couldn’t handle it. And Yes, I tried to adjust it with potentiometer, it still distorted. Installation manual required to use amplified signal from the stereo which usually you would connect to the speakers. Then the signal lowers down by Metra circuit board to make it good for the jbl amp and I think thats where problem is. Its not good idea to run the signal through preamplifier, amplifier in the head unit, and then low it down and run again through preamp and jbl amp. Basically the signal getting distorted right there when they lowering it down. Not recommend if you planning to listen the music. I think it would be ok for radio and to watch cartoons for kids. Returned and bought PAC TATO. Smarter design, they went right way. It connects through the RCA plugs with low signal and it amplifies it to the right signal for the JBL. What makes very nice sound with no distortion.Read full review
Verified purchase: Yes | Condition: New
Before buying this harness, take your radio out and check the wiring. Check if you have a factory amplifier. This harness costs a ridiculous amount of money, so make sure it works with your setup. I'm sure it works for some Toyota/Lexus cars but not all. For instance, the instructions say "connect blue wire to amp turn on wire". Problem is..there is no blue wire on this harness to connect to anything! I got the radio to turn on but not the amp, so no sound. Make sure you can return it before you buy it.
Verified purchase: Yes | Condition: Pre-owned
I bough this item to install radio Boss BV960NV into my 2003 Lexus es300. I follow the instruction on installatin guide step by step connect the wires. Finaly I direct plug into factory harness and It dont't need cut the original wire harness ,the radio worked good, perfect.
Verified purchase: Yes | Condition: New
Product was as advertised and works as such. I did however find the instructions lacking information and somewhat incomplete. I called the phone # and was walked through the connections that I had questions over. Works great!
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Wire Harnesses
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Wire Harnesses
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
