 |
Lee six cavity molds are a great improvement over their original mold designs. After receiving the mold, took about 20 minutes to degrease, smoke, and lube. Dropped perfect bullets after about a half dozen pours. Weight was plus/minus .3 grains, and diameter was dead on at .452. Tough to beat for the price.
Verified purchase: Yes | Condition: New
as with all lee products, I'm a fan. a 6 bullet mold at a reasonable price/availability. this thing throws a lot of bullets fast. I will be loading for a smith M&P 45, so bullets feeding reliably isn't even a question. for guys with 1911's...feeding reliably will ALWAYS be an issue due to it's design so stick to RN! I don't like Lee's tumble lube mold designs as tumble lubing works fine with regular grease groove designs. same for powder coating. wish list for Lee: a 140-145 gr .358 mold for 9mm/38 spl/357 mag, copy of lyman 311041, a better nose design for your rifle bullets that doesn't look so goofy (spitzer design maybe!), sell tumble lube like recluses 45/10/45!
Verified purchase: Yes | Condition: New
These molds must be cleaned prior to use, then maintain lubrication. Bees wax works good but burns off quickly. A very light coat of two cycle engine oil works very good on sprue plate and hinge points.
Verified purchase: Yes | Condition: New
Took about three times filling the mold cavities to get it figured out and working great.
Verified purchase: Yes | Condition: New
Had too have it
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Molds
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Molds
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
