Application: -RC: Taxxas Slash (2wd) -TRANS: Powder metal gears w/ diff lock -PINION- 21T -SPUR: 76T -MOTOR: 4 Pole Brushless 3600kv -POWER: 3s LiPo 30c -ESC: CASTLE Sidewinder3 w/ fan Looks and feels great, and if that's all you want them for then you might be ok. However if your looking to upgrade because your motor and tranny set up is destroying stock drive shafts, this will be no different. Pins didn't last 2 minutes and once repaired, the ball joint connecting the output shafts to the male shaft shattered in less than 1 minute.
Verified purchase: Yes | Condition: New
While I haven't broken 1 yet (only a couple of runs on them)I can immediately say they are poor quality.had to file out the ends of them before they would even slide on output shafts.the axle end is to long.....the hole for the pins is drilled out to far creating a lot of slop or side to side play of back wheels which will inevitably wear out the bearings faster and possibly create a high speed wobble effect.i wouldn't recommend! Spend the extra and buy quality
Verified purchase: Yes | Condition: New
I bought a full set for my slash 4x4 vxl on 3s, went to jump up the curb and 1/4 throttle and in mid air 2 of the 4 snap clean at the hub and diff on the 1st run Don’t waste your money on these
Verified purchase: Yes | Condition: New
Seems like good quality. Got here fast!
Verified purchase: Yes | Condition: New
Pins in the joints come out and you'll never find them again.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Cars, Trucks & Motorcycles
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Cars, Trucks & Motorcycles