 |
THE ONLY CON is that if you have older hydrant YOU MUST REMOVE THE FACTORY SEAL AT THE BOTTOM no one including the factory said anything until I contacted them again a small and large flat screwdriver and needle nose will do the trick
Verified purchase: Yes | Condition: New
This plunger is a must for rebuilding hydrants
Verified purchase: Yes | Condition: New
works great. Easy installation (once you dig up the hydrant)
Verified purchase: Yes | Condition: New
Good quality
Verified purchase: Yes | Condition: New
THIS IS THE THIRD ONE I got and all of them the thread does not match the shaft
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Valves
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
