This was about ten percent the cost compared to going and purchasing these at an Oreck retail shop. Even if you don't know how to install this on your own vacuum, it is still an awesome deal. You can purchase this here and then take it to your Oreck retail service shop and have them install it for you. You will still save upwards of fifty to sixty dollars, rather than purchase the parts through the retail outlet. I don't know about you, but my dollars just don't seem to go very far anymore. If i can save a few bucks here or there, I really have no choice in the matter than to take advantage of it.
Verified purchase: Yes | Condition: New
I just installed the new brush and belt for my Oreck XL. Took maybe 10 mins and the replacement parts fit like OEM. Brush looks well made and so do the belts. Tried out the new parts by vacuuming 2 rooms(carpet) and it cleaned well and I did not smell the belt (if slipping). Only time will tell the wear of the brush. I will be replacing the belt every 6 months(came with 6 new belts) and the brush unit 1-2 years(depends on brush wear and bearings) Last brush unit(OEM ORECK) lasted 5 years and the bearings went bad plus brush was worn down too. I can see that now the new brush unit brushes the carpet much better. Very good replacement parts that fit like OEM. Only four screws to change out the parts.
Verified purchase: Yes | Condition: New
My parents said their Oreck XL2 vaccum was much more difficult to push now that they have new carpet to vaccuum. My dad said this fixed the problem. Make sure you install the Brush Roll so the word NEW on both sides are facing upward [The jagged edge side says NEW and should face upward towards you when installing it]. I put the new belt around the motor shaft first, then around the roller, and then I had to use muscle to stretch the roller into the slot to push it down locking it in place [It wasn't easy but I got it in]. This was the best deal because it also came with 6 new belts.
Verified purchase: Yes | Condition: New
I went to a repair shop and paid $43 for a roller and one belt. I got in the car and immediately looked on eBay and found this roller and six belts for around $13. I placed the order and returned my roller to the shop. Upon arrival, I compared the roller with the old one and could see no quality differences. They work fine. Ordered another one for my sons Oreck.
Verified purchase: Yes | Condition: New
I was a little skeptical about this product being any good because of the price. Boy was I wrong. This came in a matter of 2 days and feels/looks better than the original roller that came in my Oreck. Check your roller often and replace with this combo of roller brush and belts for a lot less than the manufacturer price.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Vacuum Cleaner Parts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Vacuum Cleaner Parts