Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Pool Equipment Parts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Pool Equipment Parts
While my epoxy didn't come with the pumps pictured above, due to the super thick resin this is actually a godsend. Just buy some auto body mix cups with 2:1 ratio marked on the side and pour (or squeeze) from the jug. I was looking for a more economical solution than the big three and this epoxy was fine for the stringer, rib and sole replacement I did. It does seem to need more than 24 hours (@72°F) to really be hard enough to sand. Mixes well with a paint stirrer on a cordless drill and pigment comes out consistent that way. I set 9 Oz cloth on both sides of the floor and ribs, two layers at once on the stringers. This epoxy worked well with the tight weave on vertical surfaces, not thin enough to run out and leave the fabric dry. Working time is reasonable in the 70-80's Wish they sold this in deuces or 5's. Wish it came with product documentation Looking forward to using on bigger projects with better specs and application techniquesRead full review
Verified purchase: Yes | Condition: New
Note well that the photos show the resin in a one gallon container and the hardener in a half gallon container. This product is sold by weight and the specific gravity of the hardener and particularly the resin is much greater than 1.00. You will neither get a gallon of resin nor a half gallon of hardener. Buying it $79.99 is paying through the nose for it. Find someone who sell it buy the gallon. The pumps are cheapos.
Verified purchase: Yes | Condition: New
I used this to seal a broken solar panel. Even in 50-60 degree temperatures is hardened in 24 hours. It is crystal clear and didn't effect the output of the solar panel
Verified purchase: Yes | Condition: New
History is known in marine market. It has a 8000lbs tensile strength, DuPont is 10,000 costing 2x price to 3x. Superior on fiberglass and near identical on Carbon Fiber superior roving. NOT easy to mix, thins well 28th acetone. Does not bleach or dull dyed carbon fiber $$$ but ?? depends on $ dye. Superior product.
Verified purchase: Yes | Condition: New
Did not receive pumps but would have used mixing cups anyway. Very user friendly. Light odor if you try and smell it. Mix according to instructions and stir for at least 5 minutes scrapping the sides down then take your time. At 75 degrees F I had at least an hour of workable time before the set started. Do advise to wait the full 24 hr cure time before sanding off. Cures clear as water and very hard. Overage wipes clean with acetone. Will use again and great price comparative to the competition.
Verified purchase: Yes | Condition: New