Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Other Welding Equipment
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Other Welding Equipment
The flow meter is a MUST for anyone using a MIG or TIG welder. The bottle regulator is fine for initial set-up purposes but how can you really tell if you are running the gas at optimal pressure? This is where the pea shooter comes into it's own! Simply set the pressure at the regulator as usual and then place the rubber boss over the MIG/TIG shroud and press the trigger - please note - IF you have wire in the MIG tip it will run into the pea-shooter, so turn the wire feed to its absolute lowest! Hold it vertically and read the CFM on the dial, it will give you an accurate reading of what pressure the gas is running at. Before I purchased mine I was actually wasting gas!! Now I can set it to the correct flow rate and as a result I get better weld beads. It's a *must have* for anyone interested in MIG TIG welding.Read full review
Verified purchase: Yes | Condition: New
Very quick and easy to use. Very good for a beginner to regulate and save on gas consumption.
Verified purchase: Yes | Condition: Pre-owned
For the price this is a good bit of kit. Checked it against a digital flow meter and it was a near as made no difference, so pretty accurate.
Verified purchase: Yes | Condition: Pre-owned
Easy and simple to use. Quick way of checking gas flow at the gun end.
Verified purchase: Yes | Condition: Pre-owned
Tested yesterday and it worked great
Verified purchase: Yes | Condition: Pre-owned