CURRENTLY SOLD OUT
 | Shop by category |
{"delay":300}
|
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Other Printer & Scanner Accs
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Other Printer & Scanner Accs
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
This board came with a kit i ordered and it works great. I have had no problems out of it. I ordered extra ones so i could replace/use one on a custom build im doing. If you need solid performing board for a single extruder mendel/prusa then consider this one. It would be nice if they had included the config files because then i could configure the steps for the belt pulleys, and set up for a thermocouple instead of a thermistor.
Verified purchase: Yes | Condition: New
The board worked as expected. It's the same build quality as the original one. It even came in the original box you get inside the A8 kit. The only kinda bad thing, and that has to do with the listing not the board, is that the image shows a newer version of the board , not the v1.0. BUT, the description clearly stated that, so all is good. I had a minor issue with the sd card not being read but that probably was my sd card's fault as it was resolved after re-formating it. The USB connection worked like a charm too. The board has the OMNI firmware installed.
Verified purchase: Yes | Condition: New
Price wise is good. But when it's all wired and connected up (correctly) it not working like it should.
Verified purchase: Yes | Condition: New
It does everything it is supposed to do with no malfunctions so it is great.
Verified purchase: Yes | Condition: New
the hot bet do not work the transistor is burner
Verified purchase: Yes | Condition: New
