#1 Best Selling product in LCR Meters & Impedance Analyzers
 | Shop by category |
{"delay":300}
|
This device is true full-featured LCR. It has measurement frequencies of DC/100Hz/120Hz/1kHz/10kHz/100kHz. The highest frequency used to be the domain of only bench meters; hobby meters often only went to 1kHz or 10kHz if you were willing to pay for it. It wasn't until recently that a hobbyist could afford a 100kHz LCR. On top of this, the meter can measure theta - phase angle, D (aka tan d) - dissipation factor, ESR, Q, series and parallel inductance, series and parallel capacitance, series and parallel resistance. It also has the ability to sort into bins:±0.25%, ±0.5%, ± 1%, ±2%, ±5%, ±10%, ±20%, and -20%+80%. Agilent has a similar handheld meter,the U1733C which costs ~$400. Basically all of these features are present on the Agilent and the Der EE, though the Agilent has one extra resistance range and has a few tenths of a percentage better accuracy on some ranges (for 4-5x the price). Great value for money.Read full review
Verified purchase: Yes | Condition: New
An LCR with quite a good spec for the money - it would be nicer with a better kelvin clip design and longer leads (see the uploaded mod on YouTube). Mine didn't come with a hard carrying case - though they are listed (but not easy to source) my operating manual wasn't in English - but they are easily downloaded if you're on the interweb 30% extra to pay (VAT and handling, import duty etc)
Verified purchase: Yes | Condition: New
A good kit together with the robust and well made meter, allows rapid determination of capacitor health (other than leakage) at the appropriate frequency and is a good tool for matching Q values in various design projects. It’s a shame that I cannot set a default test frequency (or I haven’t found how to do it). Tight spacing of the component test socket allows small components to be tested easily. Blue backlight not ideal for contrast but illumination is even and the display is clear. A very good addition for the bench at this price point.
Verified purchase: Yes | Condition: New
non brand 470uf cap reads 392uf 1khz 0.19 esr and 415uf 100hz 0.2 esr on a zoyi meter 457uf and a Bryman 235 463uf ATmega tester 437uf 1.6esr then tested my DE5000 alongside an older 5y old DE5000 read 394uf Conclusion the DE5000 must be true readings compared to the other equipment. low resistance measurements for wire wound resistors 1ohm , 0.3, were very accurate all tests with the supplied short alligator. I wait for some kelvin clips to make up a test lead to replace the aligators.
Verified purchase: Yes | Condition: New
Got the product, calibrated it quite easly, used it no problems. smart device, finds out what it is measuring, caps or inductors, gives fast results. cant tell anything about accuracy yet, dont have any cap reference device but measuring various caps / inductors, it gave me close results to the theoretical calculations i made its light, its portable, it works as advertised. im happy.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in LCR Meters & Impedance Analyzers
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on LCR Meters & Impedance Analyzers
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
