Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Engraving
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Engraving
You should replace the laser driver and board power supply when you get it, they are very cheap. The power supply weighs only ounces, same with laser driver. Seems to have no heat management. The control.boards seems like a standard RAMPS derivative, except scaled down for two axis and run by a nano. The frame is of good quality and they give you plenty of extra hardware. No instructions, however, so you'll have to.manage from looking at the pictures. I will provide build instructions later at pappad.info/wood Also.wpuld recommend zip tying a wooden dowel to the x axis, and tie the cables to that because otherwise the kit may eat itself! See attached photo.
Verified purchase: Yes | Condition: Pre-owned
Есть конечно возможности для доработки и улучшений. Но в целом, Это необходимый и достаточный набор для лазерной гравировки.
Verified purchase: Yes | Condition: Pre-owned