scorpionmouse on eBay

About

Location: United StatesMember since: Aug 10, 2002

Feedback ratings

Last 12 months

Positive10- positive feedback in last 12 months

Neutral0- neutral feedback in last 12 months

Negative0- negative feedback in last 12 months

All feedback (829)

juuehfs (2428)- Feedback left by buyer.
Past month
Verified purchase
Quick response and fast payment. Perfect! THANKS!!
reddingfasteners (126965)- Feedback left by buyer.
Past 6 months
Verified purchase
Quick response and fast payment. Perfect! THANKS!!
cd8831 (754)- Feedback left by buyer.
Past 6 months
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
*****- Feedback left by buyer.
Past 6 months
Verified purchase
Fast transaction, GOOD feedback ! It has been shipped.A++++
kblautoparts- Feedback left by buyer.
Past 6 months
Verified purchase
Fast payment. Perfect! THANKS!!
detroitaxle (1046715)- Feedback left by buyer.
Past 6 months
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.

See all feedback

Reviews (6)

New 2.5" to 3.5" Bay SSD HDD Adapter Notebook Hard Disk Drive Mounting Bracket B

May 24, 2016

A good but mislabled item. Works for SSDs only.

I only recommend these for Solid State Drives. Definitely not for mounting a laptop drive in a 3.5' bay. These are described as being for 2.5" hard drives but they are really made for SSD drives. The slot is much too narrow to fit anything but some really thin laptop drives. I tried with several different laptop drives and all would not fit the slot without cutting some plastic away from this adapter. SSDs fit without a problem and just snap in. Also could not get these to fit into a 3.5" caddy or carrier for mounting into a standard desktop case bay without drilling an extra hole in the 3.5" caddy to line up the screws.

Lisle 75500 Combustion Leak Detector Kit

Apr 02, 2016

Disappointing performance

The tester came with poor instructions which makes following the test procedure impossible. There are supposed to be two connectors for drawing vapor through the fluid, one red one silver. Both are silver, but different no way to tell which is correct. The testing tube uses a check valve on the bottom to keep the fluid in the tube during the test. It doesn't. The blue liquid drains into the cooling system before enough vapor is pulled through to get a result. Ended up wasting half the test fluid trying to finish one test. The test was totally inconclusive. The fluid turned greenish once, but it turned out to have sucked in some antifreeze.

(10) M16-2.0 Metric Hex Flange Nuts Class 10 DIN 6923 - Phos & Oil Finish

Aug 26, 2016

Truly poor quality control

As soon as these arrived they were test fit over the truck suspension arm bolts they were purchased for only to find the fit was inconsistent. The nuts fit from barely snug to frighteningly loose. These have such bad tolerances they aren't worth using. 4 of the 10 bought just fit closely enough on the threads to be considered the right size. The rest are so loose there will be no way to tighten them without something stripping. To insure this wasn't a problem with the bolts all the nuts were test fit to the same bolt. Then they were moved to the next bolt and re-tested in the same order. The results were the same. The same 4 nuts fit closely and the rest could be wobbled back and forth anywhere on the threads. Out of a bag of 10 this was a 60% failure rate for size tolerance. That makes the cost for nut higher than almost any other name brand. I can only assume if the stamping process was this far off that I can't trust the grade rating either.

See all reviews