Skip to main content
clem-clone

clem-clone

5 items sold
1 follower
Contact
Contact

Shop by category

clem-clone
All categories

All items

See All

About

Location: United StatesMember since: Aug 16, 2011

Feedback ratings

Last 12 months

Positive31- positive feedback in last 12 months
Neutral0- neutral feedback in last 12 months
Negative0- negative feedback in last 12 months

All feedback (146)

  • l***r (597)- Feedback left by buyer.
    Past year
    Verified purchase
    A+ seller. Shipped fast, packaging was excellent, received as described. Great transaction.
  • invotech (12930)- Feedback left by buyer.
    Past 6 months
    Verified purchase
    Hope to deal with you again. Thank you.
  • *****- Feedback left by buyer.
    Past 6 months
    Verified purchase
    Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.
  • activeparts (31493)- Feedback left by buyer.
    Past 6 months
    Verified purchase
    Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.
  • ncmart2000 (4864)- Feedback left by buyer.
    Past 6 months
    Verified purchase
    Good buyer, prompt payment, valued customer, highly recommended.
  • *****- Feedback left by buyer.
    Past 6 months
    Verified purchase
    Good buyer, prompt payment, valued customer, highly recommended.
See all feedback
Reviews (2)
2005-2008 Porsche 911 997 Boxster Cayman 987 PSM Stability Control Switch Bank 9
Jun 22, 2021
Replacement part works well
An annoying problem with this switch. It worked, then it didn't. I took it apart but couldn't find anything wrong, as it's a passive circuit board. I ordered the replacement part and it worked immediately. I took the old one apart again and discovered the problem. I took it apart and noticed these were all passive components, just switch contacts, resistors for the LEDs and the LEDs, all leading to the set of connector pins. I traced the switch circuits first and discovered no continuity through the 'feed-thrus' or 'vids' the small holes that routed the circuitry from one side of the board to the other. My solution was to scrape away some of the coatings at the feed-thrus and solder a small wire thru the hole. The hole should be plated-thru but this was obviously the weak point with these very small holes. I did this for both switches. The LED circuits were fine. I found the '+' and '-" points on the connector, connected that to my bench power supply and confirmed the LEDs worked. I cleaned it all up, re-assembled it and it works perfectly again. It will be my spare
Power Supply 300W iMac 27 2012 2013 5K 2014 2015 2017 2019 2020 A1419 A2115
Jul 19, 2025
Thank you, this works great...
Thank you, this works great
See all reviews

About

Use this space to tell other eBay members about yourself and what you’re passionate about. Give people more reasons to follow you!1/1000