My original reason for purchasing this punch toolset was to replace the sights on my Henry Big Bog 357 with Truglo sights. Since the Henry uses dovetail sights a brass punch as needed to remove the front and rear buckhorn sights. I used the correct sized brass punch to remove the old sights and installed the new ones. Took about 10 minutes total. Great toolset to have on hand and I will be using this toolset for replacing my sights on at least one of my handguns.
Verified purchase: Yes | Condition: New
Was excited to get my new set of punches & they looked good in the box, but ......Used the all steel punches for the 1st time to drive out the stubborn front sight post/gas block pins on an AR-15. Both broke. Had to rely on an old set of Craftsman punches to get the job done.
Verified purchase: Yes | Condition: New
super high quality, top of the line at a very affordable price. don't wait till the ATF comes to take these from your cold dead hands. hurry and buy in quantity. you most likely won't regret this
Verified purchase: Yes | Condition: New
Good quality, a little smaller than it looks in the photo. But that's no problem. Nice to have all your punches in one neat container. Worth the buy !
Verified purchase: Yes | Condition: New
This set is easily a contender for the best entry level punch set. The hammer isn't too light like with some other kits at this price and the punches seem to be well made. They feel solid and the kit comes with two 1/16 pins, which work great for the sight retention pin in the CZ-75.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Smithing Equipment
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Smithing Equipment