I have a 2013 Wrangler and my check engine light came on with the error code P0520, so I did further research into it and came to find that the oil pressure sending unit was bad for whatever reason... So I bought a new one, switched the old one out and now my check engine light is gone! The Jeep is now running back to normal and also sounding much better.
Verified purchase: Yes | Condition: New
This part was just what I needed to fix my repeated check engine light coming on. Its hard to believe there was a problem as the oil pressure was great and the old sender showed that it was, but an update to the ECM for a recall seamed to have caused this to happen. So there must be something in the update that was causing it code. Now it is working great!
Verified purchase: Yes | Condition: New
This OEM Mopar sensor is the ONLY fix for a check engine light low oil pressure code. Don't even bother with aftermarket. Ask me why I know...
Verified purchase: Yes | Condition: New
It fit, it works. Expected a factory Mopar part. Not sure that's what I received (no Mopar logo visible) but everything else seemed right and quality seemed high. Arrived earlier than expected as well. Hard to beat that.
Verified purchase: Yes | Condition: New
There are tons of these things out there from 10 bucks to a hundred and thirty, but if you take the time to read the reviews, only the Mopar ones deliver proper operation. This one installed and worked perfectly right out of the box. Money (reluctantly) well spent. Starting and idle problem cured.
Verified purchase: Yes | Condition: New
Worked Great-- Check Engine light off after a few driving cycles.
Verified purchase: Yes | Condition: Pre-owned
I bought this new oil pressure sensing unit when the OEM sensor on my 2014 Jeep GC went bad after only 46,000 miles. It would have been like a 5 second job if the brilliant engineers didn't put the damn thing UNDER THE TWO PIECE INTAKE MANIFOLD!!! Three hours later and some blood loss I fired it up and viola the gauge is happy again ;) Highly recommend this unit and be sure if your getting a replacement buy the newer 5149062AB unit not the AA. This might be the new and improved model because there is no way a sending unit should have gone bad in less than 100K miles.
Verified purchase: Yes | Condition: New
OEM almost always fits and works. I say almost because not everything is always perfect. I have put on more than a few parts new ( I am a professional mechanic with over 38 years experience) that didn't work. BUT, if you buy from a dealer, even online, you get a WARRANTY! You can get it warranteed at your local dealer FOR FREE! You don't have to send it back where you bought it from!
Verified purchase: Yes | Condition: New
Used an inferior switch. Register oil pressure, but the wiring was inferior. Mopar uses only the best parts for dodge, jeep, and chrysler vehicles. Prices are about the same. Don't trust 3rd party parts. Stormy Rowe
Verified purchase: Yes | Condition: New
Very nice OEM switch at a good price. Thanks MG.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Engine Sensors & Switches
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Engine Sensors & Switches