These are good quality for replacing your float bowl gaskets. They first will look like it might be a little small and thats because it hasn't been broken in yet. My advice is to put the gaskets in hot water for a couple of minutes and they should be good to go. If you ever come across a problem where these gaskets becomes too large for the float bowl. Thats because gas has touched the rubber and is trying to expand it. Again, just leave it in hot water for a few minutes and let it dry. Works like a charm. Would buy again from them!
Verified purchase: Yes | Condition: New
These gaskets are roughly the same size and shape on the factory gaskets but they are a tad misshapen. I had to heat them up with a heat gun and hold them into place with a C clamp while they cooled so that they would stay in place while I put the bowls onto the carburetor. They are definitely not press and mount as they should be.
Verified purchase: Yes | Condition: New
Almost perfect fit. Got the job done.
Verified purchase: Yes | Condition: New
Got my carbs rebuilt with these and bikes running great
Verified purchase: Yes | Condition: New
kind of expensive but exact match and worked great , im a happy custome .
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Gaskets, Seals & O-Rings
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Gaskets, Seals & O-Rings
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
