Fit in a 2004 Chrysler PT Cruiser with 120 MPH Speedometer!
This add-on takes some work. Not only does the instrument cluster have to come out, but the needles need to come off to place the overlays onto the gauges. I used small pieces of tape to hold the overlay in place while I replaced the needles. It's best to take pictures of the gauges powered up for reference to put the needles back on. I made sure the gas tank was very full before doing this, and the engine was stone cold. Use care when moving the instrument cluster on the bench, since the needles on the gauges will move as you tilt the cluster. Make sure the needles return to the proper position before removing them. I removed the dimmer control from the mounting panel, and drilled a hole below the wiper actuator to install the dimmer there. Then attach the red wire to the yellow wire coming out of the multi function switch, and ground the black wire to the aluminum bracket holding the multi-function switch. Works like a champ, I can see the gauges and the needles now when it's dark!