CURRENTLY SOLD OUT
 | Shop by category |
{"delay":300}
|
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Other Telescope Parts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Other Telescope Parts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
Ordered this on reviewers recommendations. Works well on std Meade etx125. Just remember to read Autostar handset home instructions on lnt setup prompt and all will be well. Brand new with printed instructions.
Verified purchase: Yes | Condition: New
Did not work on my meade lx90 12" ACF. Works on recently made meade lx90's. Mine is 2 years old and Meade support says the logic for its support was put in recently. Mine was made prior to the logic addition. Could not find North and spun the telescope clockwise and had to turn off the power to get it to stop.
Verified purchase: Yes | Condition: New
I have just tested the LNT smartfinder module with my LT-8 and I can confirm that it is working flowlessly. I have permanently glued the LNT on the telescope. In the Audiostar I can set the red dot blink, I can do the auto alignment and the sensor calibration. Also, because I have added the StarGPS module with StarPatch update, the time provided by LNT is ignored and the gps time it is used instead.
Verified purchase: Yes | Condition: New
I was a little bit worried that it wouldn't work with the Non PE edition of ETX-90, but it worked flawlessly. It makes it trivial to properly norht align and level the telescope for the initial alignment procedures. It also fits much better than the (really bad) red dot finder that comes with the ETX, so it doesn't move as much when aligning it with the OTA
Verified purchase: Yes | Condition: New
Worked 100% plug & play. If it is not working with your Audiostar use starpatch to patch your firmware, not Meade's software as it corrupts the data. Has nothing to do with "logic" in the scope it self. Turned a newer lx90 into an LNT model! All automatic again!
Verified purchase: Yes | Condition: New
