I was very impressed with this item. I put it in my 2008 Teryx Side by side and it fit great! It came with all of the speaker wires, power and Ground wire, One set of RCA jacks and an antenna all pre-sealed in the box minus a Yellow-Constant power and a Remote wire which I just drilled two small holes, added and sealed them. It came with 3 face plates. The old school dual nob, a single DIN and a smaller rectangular one that is pretty much universal (With slight modifications) for anything you would need to get out of the weather. All and all I was very impressed with the overall quality and look of this unit! Thank you!!
Verified purchase: Yes | Condition: New
I bought this to install my radio in my boat. It arrived today and I got right to installing the radio in the housing . The first thing I noticed is that the wiring is very light duty. perhaps it is 16 gauge . going through the wiring I then noticed that there is no wire for the accessory position . your radio is either on all the time, or completely off with the key. if you wire it this way you have to reset the stations, and the clock each time you cycle the key switch. [I drilled an hole and added a wire] Next I assembled the radio in the housing, then tried to attach the mounting bracket. first the screw knobs would not fit through the holes in the bracket. [more drilling] then the screw would not thread into the brass insert , it ended up striping the brass insert out of the housing. I had to glue it back in . the I had to fix the threads on the knob using a 6mm die nut . So it end up that while I am going to use this thing, in hindsight I would not buy it again. it is a PYLE for sureRead full review
Verified purchase: Yes | Condition: New
This is just what I needed to mount a 1 din auto stereo in my boat. The wiring colors don't match the ones on stereo, also I had to drill another hole so there was a wire for the always hot on the stereo I have. Mounted it under dash with furnished bracket but it wouldn't stop housing from loosening up in rough water I added a brace to back of housing to hold it still. This could be used in a lot of out in the weather applications.
Verified purchase: Yes | Condition: New
Overall its really good for my needs so minimize the downsides if they arent important to you. 1.) If you need the cover (I dont) you can expect it to have broken plastic hinge pins (soon) and that makes the cover unrepairable (ever) ... and they are not strong. I lifted the lid (with some force) and they broke off. 2.)HANDLE: The handle is plastic too but it seems durable enough for me. 3.)WIRES OUT:I had to drill openings for "continuous 12V" and for "bluetooth mike" wires. the antenna connector is good. the wires are very very small gauge but the inside wires give enough room for you to hook up your radio. 4.)SUGGESTIONS: it doesnt have to be pretty so why not eliminate the curves a bit to have more space inside (heat dis and wire space) also, make the cover pins repairable...REM: It works fine for me because i dont need to seal it upRead full review
Verified purchase: Yes | Condition: New
Color coded wires provided to make connections to receiver were incorrect for my receiver. I pulled them out and drilled holes I could run my existing wires thru saving unnecessary confusion and extra connections. I'm satisfied with the result.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Marine Audio
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Marine Audio