CURRENTLY SOLD OUT
 | Shop by category |
{"delay":300}
|
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Rifle Parts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Rifle Parts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
I wanted to add a fore grip to my rifle that would give me more control of the rifle and allow my support hand to be able to pull the gun into my shoulder. I didn't want a grip with a lot of bulk, weight or a large profile. This AFG is perfect. It is reasonably priced, attaches to my MLOK hand guard and is very low profile. It just works well for me and looks great on my rifle. It's made by Magpul. How can you go wrong.
Verified purchase: Yes | Condition: Pre-owned
If your AR will accept a Magpul AFG2, that is the way to go. The AFG Maglock is not as comfortable or as natural a grip as the AFG 2. You need to have a weaver or picatiny rail in order to use the AFG 2. However, the AFG Maglock has the ability to mount on a USGI forend for a lighter weight weapon.
Verified purchase: Yes | Condition: New
The Magpul Angled Fore grip takes a little getting used to, as you will need to decide exactly how you want to hold onto it. The M-Lok system is also a bit different, so read the installation instructions (go online if needed). Once you get it properly installed, you can then decide how to find the best purchase for your hand. The grip angle is quite a bit easier on the wrist than holding the horizontal fore grip of your rifle bare. It also makes it easier to pick up your rifle by the fore grip without it inadvertently sliding out of your hand - a real plus. As always, Magpul makes a very sturdy, well made product, and I would not discourage anyone from buying anything Magpul. On the downside, this particular piece is not very cheap, but still worth it if you are going to use it a lot.
Verified purchase: Yes | Condition: New
Nice Magpul product. Solid, quality construction. Fits my PSA AR pistol nicely. I have large hands and I wear extra large gloves. My hands (without gloves) do not fit in between the two ends. I kind of have to cup the bottom end of the grip with my last two fingers. If you have average or smaller hands this grip will be a perfect fit. Regardless, this is a nice grip.
Verified purchase: Yes | Condition: New
I have tried several other fancy looking aluminum foregrips but the Magpul fits my grip just right. It's well made and Magpul even thought of putting thread-locker on the installation screws.
Verified purchase: Yes | Condition: Pre-owned
