Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Rifle Parts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Rifle Parts
I finally installed this item and found that it operates perfectly and the appearance is nice. It is great to be able to actually grasp the charger handle now that this is installed. However, the spring bar on this charger is about an 1/8 of an inch longer than the Ruger item and it is somewhat difficult to install...it actually touches the forward most end of the receiver. Once you figure that out, it is installed and functions quite nicely
Verified purchase: Yes | Condition: New
The handle feels of good quality and looks good. However, I could not achieve reliable feeding with this handle installed in a factory Ruger receiver, factory bolt, and feeding CCI mini mags. From what I can tell, the fitting of the handle to the guide rod is either too tight or too loose so that it takes a great deal of effort to cycle the action. I ended up putting the factory handle and rod back in the gun for the time being. Have had no issues feeding since then with various types of ammo.
Verified purchase: Yes | Condition: New
looks very nice.. about 1/8" too long and had to put it on bench grinder to take it down some to actually fit in the rifle. after that though, slightly oversized and had to use oil and wear down a spot to remove some paint and such on rifle... now it works great. compared to the $80 units, this $20 is definitely work the trouble you go through to make it good.
Verified purchase: Yes | Condition: New
Installed this, pulled bolt back and would not move forward, stuck in rear position. Uninstalled and reinstalled about 4-5 times, same issue. Once I reinstalled the stock charger handle all was good, but had to return this. The rod and spring is longer, which I believe the spring bunches up and presses into the actual bolt, causing the binding. Others did ok, but keep this in mind. I ended up purchasing a bolt handle itself to lock onto the oem handle.
Verified purchase: Yes | Condition: New
I will preface this comment to by informing you that I have quite a bit of experience in assembling and upgrading the Ruger 10/22 ..... along with having reasonably high mechanical aptitude and having proper gunsmithing equipment specific to my build . Not happy at all about this item ; the roll pin looked smashed into place when I received this charging handle combo.... but I figured maybe it wouldn’t matter. I installed said charging handle after a full teardown and cleaning/ lubing of my bolt/trigger assembly and even removed the barrel in order to check clearances to ensure thing were “to specification “ . Upon installation of you item ; I noted that the handle would “ride” the bolt assembly and showed wear after cycling without ANY ammunition *(hand cycling after lube) . Furthermore after firing live ammunition, the roll pin sheared off my charging assembly came apart almost sideways with the spring jamming into my receiver. UNNACEPTABLE .Read full review
Verified purchase: Yes | Condition: New