Nice little extra to hang on to. soft rubber and the pebbles are not hard on the hands. I added a pierce floor plate to mt 10 rnd mag and it has a lip on it .so with the finger grove lip and the lip on the floor plate , you couldn't force this gun out of my hands. and it is really easy to hang onto when shooting. It is the perfect grip for my hands. as far s installation I put the front on about a 1/4 inch or so then stretched the rear on each time pulling it up and outward this stretched the grip a little, then working it up alternating front rear front rear. it went right on
Verified purchase: Yes | Condition: New
I have other Hogue Handalls and Hogue grips which were easy to install and worth every penny. The unit for the SigP365 is a great disappointment in that installing it requires crafting items from the plastic packaging. It then requires more hands, hand strength and dexterity than I possess to wrestle it onto the gun..Any prospective buyer should be warned how difficult it is to install. My Hogue Handall for the P365 has been relegated to the parts bin where I may someday find a use for it.
Verified purchase: Yes | Condition: New
After long consideration, and reading lots of reviews , both good and bad. I finally purchased a Sig P365. I took it down and cleaned and oiled it and went to the range. I then shot about 250 shells through it. 3 kinds FMJ, 3 kinds hollow points. It ate everything with no issues. I'm very glad I bought it. Dependable, accurate, easy to conceal. Only 1 issue as far as I'm concerned. The grip is a little small for a man that is 6' 4" and has very large hands. The remedy was the 12rd magazine and this Hogue beavertail rubber grip. Grip makes all the difference in the world. Adds a minimal amount to the circumference of the factory grip, but along with the extended mag. Turns this into a very accurate fun gun to shoot, yet still very concealable for pocket carry.
Verified purchase: Yes | Condition: New
These make holding a small pistol Much Easier ! They have a 'Grippy' texture to them and really improve the grip...they also last very well, and protect the guns grip from damage...I used this one on a Ruger .380 LCP Max because Hogue does not have one for it...and it's a near perfect fit for the pistol...I Reccomend Hogue for every gun !!!!
Verified purchase: Yes | Condition: New
I was a little skeptical about this handgrip. Yeah, it takes a little bit of coordination to get it on.... but I was pleasantly surprised at how comfortable and sturdy it is. I would prefer to wrestle it onto the gun rather than have it loose and flimsy. I have bigger hands and this (with the extended magazine base plate) really makes this a comfortable gun. Take the instructions with a grain of salt.... use a couple of plasticware knives, fork handles, or something of the sort instead of cutting up the packaging. PS... Using a hair dryer to warm it up first really helps.
Verified purchase: Yes | Condition: New
Great product, when I got it on it was comfortable easy to grip and gave me great control. it is hard to get on but worth. dont waste your time with the instructions stick it in a pot of water heat it up for a few minutes until it feels softer it still a struggle to put on but it helps alot. it does add thickness to your grip so after you get it on go test it and make sure its going to work for you especially if its going on your (edc) every day carry
Verified purchase: Yes | Condition: New
I use my p365 for edc. The hogue grip adds a little more material for my average male size hands to hold on too. Plus it makes my gun look more appealing. I really like the extra little bit more size it adds to the handle though. Really helps with the control of the gun.
Verified purchase: Yes | Condition: New
Perfect fit for P365. Installation was easy as long as you watched the manufacture video beforehand. The sleeve helps increased the girth of the grip handle and made it comfortable for maintaining a tight grip. A must have addition for carry P365.
Verified purchase: Yes | Condition: New
Fits perfectly, fairly easy to install, and makes a huge difference in the feel of the P365 in hand. I just soaked it in very hot water for 5 minutes and stretched it on. Used a bit of window cleaner as a lubricant.
Verified purchase: Yes | Condition: New
I love the P365 but would have liked a little more palm swell and grip traction. The Hogue Bevertail Grip Sleeve adds just enough of both and really makes the P365 feel like a larger pistol. I almost went with Talon Grips because I've always had good luck with them in the past and I was afraid the Hogue might slip on the grip if it got wet. I'm so glad I went with the Hogue because it doesn't slip, feels great and in my opinion, looks better. I highly recommend you give them a try.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Pistol Parts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Pistol Parts