Up for sale is a powerhead for a Johnson 5.5hp outboard motor. The year is estimated to be a 1959. The serial number is 2181389. From what I can see, the cylinders are in decent condition, as are the pistons and rings.
<p dir="ltr"> Johnson 1988 30 HP complete power head, used, 120 PSI Both Cylinders This came from a running out board there are no broken bolts studs or stripped threads The only issue yes the water temperature Brown wire has been caught approximately 1" from the block model # J30ELCCE</p>
All the cylinders have been bored to a maximum of. 030, the pistons, rings, wristpins, and all bearings have been replaced, and the powerhead has been repainted. A Gasket Kit is included in the order, as is a Limited One-Year Warranty.
1956 JOHNSON 10HP 15HP FACE PLATE KILL SWITCH AND MORE. 15HP JOHNSON OUTBOARD. MIGHT ALSO BE CORRECT FOR A 1955 10HP. THE RUBBER GASKET. (better than most at this age) KILL SWITCH MIGHT BE A 1958. LOW SPEED MIXTURE SCREW DOES HAVE A LITTLE WEAR ON THE TIP.
Rebuilt '80's Johnson, Evinrude, OMC Sea Drive powerhead assembly with full dressing less functioning VRO fuel/oil pump assembly (pictured unit acting as a placeholder only). I reserve the right of carrier selection but may be open to requests or suggestions.
Bought this motor with plans of using it but it wouldn’t shift, when I droped the lower unit it was rusty and broken lever, decided it would be too costly. This is the center exhaust section complete as pictured.
For sale is a good used cylinder head that was removed from a 2005 Johnson DF 25/30HP 4-stroke outboard motor that we are parting out. This item is in good condition and was removed from a good running freshwater motor.
Evinrude Etec 2008 60hp powerhead used, good compression. This unit will fit various 2008 and later, 40hp - 65hp Johsnon Etec outboard engines. this used powerhead was disassembled, checked, bored and honed and cleaned and professionally reassembled with new gaskets, pistons, rings and seals so you can be sure you’re getting the best possible used power head.
For sale is a good used short block that was removed from a 2005 Johnson DF 25/30HP 4-stroke outboard motor that we are parting out. This powerhead is in good condition and was removed from a good running freshwater motor.
PN: 5006097. Evinrude Etec 2006 60hp powerhead used, good compression. This unit will fit various 2006 and 2007, 40hp, 50hp, 60hp Johnson Etec outboard engines. This was removed from a 2006 60hp Johnson Evinrude Etec Model: E60DPLSDA.
<p dir="ltr">Johnson 6hp Outboard Motor Vintage Nice See Description. Condition is For parts or not working.</p>%0a<p dir="ltr">The control arm connectors have been broken off, it can possibly be welded. The engine itself is in excellent shape, and a few pulls of the starter cable make me think it would turn right over if connected, and it feels like there is decent compression. All that considered, its being sold for parts/as is.</p>%0a<p dir="ltr">It will be well packed.</p>%0a<p dir="ltr">Thanks for looking.</p>