Ford F-250 Dash Parts
The dashboard on your F-250 is your window into the inner workings of your Ford truck. As such, it’s of vital importance that this complex arrangement of instruments, gauges, and displays stays in proper working order. Finding the right Ford F-250 dashboard parts is easy with this comprehensive collection.What types of dash parts are there for the F-250?
One of the most common dashboard upgrades for Ford trucks is a built-in GPS system. These handy devices let you know where you are anywhere in the country from a small display embedded in the dashboard. To take advantage of a gadget like this, though, you may need to upgrade to a new dashboard housing.How do you install a GPS in a Ford F-250?
Installing a new GPS system in your Ford is easy and requires basic technical knowledge, electrical tape, and about an hour of labor. Follow these simple instructions to get started with GPS technology in your vehicle.
- Remove the plastic panel on the driver’s side to the left of the wheel, and insert the GPS antenna. Make sure that the antenna is facing up and that there is no metal blocking the signal.
- Remove the panel below the steering wheel to install the GPS electrical plug. Basic knowledge of the wiring schematics in your truck is required.
- Install the GPS monitor in the dash, and connect the antenna and electrical plug.
- Replace the plastic panels to cover the wiring and fire up the GPS to ensure that it is operating correctly.
The front trim piece is what holds everything together in the dashboard of your Ford F-250 Super Duty. Replacing this part is simple and takes about 30 minutes.
- Engage the emergency brake and start the engine. Move the shifter to the lowest position.
- Lower the steering column to its lowest position and remove the dash trim by working your fingers into the seam on the far right and moving toward the center until it comes free.
- Install the new dash trim piece by lining it up and gently pushing it into place.
The duct vents in your Ford F-250 Super Duty are delicate and finicky and require regular cleaning. When it comes time to replace these parts, follow these simple instructions to remove them and get started with something new. Instructions may vary slightly based on the year of manufacture.
- Acquire a flat head screwdriver, and wrap it with electrical tape starting about half an inch away from the tip.
- Pick a vent to start with, and insert the head of the screwdriver along the edge of the vent to pry it gently out. Move the screwdriver all along the edge of the vent to remove it from the dash.
- Repeat this process for the other three duct vents, and thoroughly clean the sockets. Insert the new duct vents by pushing them gently into the sockets.