Computer Drive Cables & Adapters

The SD-CF-IDE-BR is an adapter for connecting a compact flash memory card to a 3.5 IDE host interface, aiming at educational sectors, IT development, and the embedded technology enthusiast to enable the use of a compact flash card as an IDE hard drive. Features: No external power needed when used on VIAs EPIA series motherboard On-board LED indicators for power-on and compact flash access Voltage selection for 3.3V / 5V compact flash Master / Slave mode selection Fully compatible with CF Type I, II & Micro Drive 40-2ay ( 2.54mm ) standard IDE connector Power input: 5V, floppy disk Drive power connector Board Size: 61 X 52 X 0.8mm Applications:Linux-based set-top boxes, routers, firewalls Diskless network clients Industrial computers System Requirements:PC or Mac with one IDE.

The cable supports UASP, allowing for transfer speeds up to 70% faster than conventional USB 3.0, which enables you to utilize the full potential of your SATA III SSD/HDD, when paired with a UASP-enabled host controller. .

These cable are built with top-quality components. • Universal Floppy Drive Ribbon Cable. For 3.5 and/or 5.25in floppy drives. • Replace worn out floppy drive cables. []--------------22"--------------[]----1"----[]---------10"---------[]----1"----[].

External SATA (eSATA) cables are designed to connect external SATA devices to either external SATA ports or internal SATA connectors. Unlike cables for internal applications, eSATA cabling must be shielded. The eSATA connectors are keyed differently, to prevent the use of internal SATA cables in external applications. While internal SATA connectors have an "L" shaped key, eSATA connectors use smaller, vertically offset keys. This shielded eSATA cable is certified to perform to SATA 6 Gbps performance standards. Each end is terminated in an eSATA connector for use with external SATA devices and controller ports only.

Socket 2 B key M.2 NGFF SSD(SATA transfer mode) to 2.5" SATA adapter. Support the 22 30 mm/22 42 mm/22 60 mm/22 80 mm size of M.2 NGFF (SATA) SSD. Type NGFF SSD to 2.5 SATA Adapter Card Case. 1 x NGFF SSD to 2.5 SATA Adapter Card Case.

Good quality wire and construction Wire: 20AWG Copper Split a single SATA power connector into two so you can power more devices with your existing power supply.

Unused in original Supermicro bag.

1 x 2.5" Hard Drive Enclosure. LED indicator: Blue. 1 x USB 3.0 Cable. Interface: USB 3.0. Tool-free installation, hot-swap plug and play. To Fit: 2.5" Drive. Product Specification.

This Laptop 2.5 inch to Desktop 3.5 inch IDE Hard Drive adapter allows you to convert your Laptop Hard Drive into a 3.5 inch IDE hard drive for use on your desktop. 1. allows you to convert a notebook hard drive for use into a desktop system. 2. you can easily connect your 2.5in notebook IDE hard drive to a 40-pin IDE cable for installation in a desktop or tower PC. 3. Cable Adapter - IDE / EIDE adapter   Type: IDE / EIDE adapter   Connector(s): 1 x 44 PIN IDC - female   Connector(s) (Other Side): 1 x 40 PIN IDC - male 1 x power 4-pole - male4. Works with all laptop hard drives, including Dell, Sony, IBM, Toshiba, HP, Compaq, and Fujitsu.

These 18" SATA data cables connect SATA hard drives to the motherboard of your PC, server or other SATA compatible devices. Compatible with SATA I / II / III. Connectors: straight, L-shaped. Single Unit.

USB 2.0 to IDE/SATA drive adapter turns any standard IDE or SATA drive into a convenient external drive. 1 x USB 2.0 to IDE SATA Adaptor Cable. SATA cable Length: 40cm / 15.75in. USB Cable Length: 62cm / 24.41in.

Lycom DT-120 M.2 NGFF PCIe based SSD works in main board PCIe x4 bus slot. It is designed to work only with 'M' key M.2 PCIe SSD such as Samsung XP9xx SSD. Not compatible with a 'B' key M.2 PCIe x2 SSD or 'B' key M.2 SATA SSD.

DB25 Parallel to Centronics CN50 SCSI connector adapter.*Monoprice continually strives to improve its product line to bring our customers the best products available. Therefore, changes may be made to listed specifications without prior notice. Item received may not match photo or specs shown.

3ft DB25 Male to CN50 Male SCSI 25-Conductors Cable. This cable features the DB25 connector found on SCSI host adapters on PCs or Macs and the Centronics 50-pin connector most often found on peripherals.

USB 3.0 to SATA 15 7 pin connector. 1 PC USB 3.0 To SATA Cable. Black Color w/ Blue Tip. Length: 50cm/1.5FT.

Fan Speed: 8,500 RPM. 40 x 40 x 28mm Axial Fan. Hours of Operation.

Click here to see description.

SuperMicro SATA Cable Set CBL-0180L-01.

Serial Attached SCSI (SAS) is a high-speed data storage interface designed for high-throughput and fast data access. Intended primarily for data storage centers, the SAS interface is backwards compatible with SATA.

Content PNY NVIDIA Quadro Stereo Bracket. Manufacturer NVIDIA / PNY.

Connectors: 40-Pin Male to 40-Pin Female. Cable has the full 40-Pins (Pin 20 is not Blocked).

3ft CN50 Male to CN50 Male 50 Conductors SCSI Peripheral Cable. CablesOnline Part Number: SC-105. 50 Conductors. Length: 3ft. (2) Centronics 50-Pin Male. SCSI-1 Centronics 50 Male/Male Peripheral Cable.

Each major revision of the Serial ATA interface specification has doubled the maximum data transfer rate. The latest SATA Revision 3.0 allows for data transfer speeds of up to 6 Gb/s. While the cables for all three revisions appear to be similar and will physically fit into the connectors on all SATA drives and controllers, the higher data transfer rate of SATA 6 Gb/s requires higher quality materials and closer tolerances than the previous two revisions required. Monoprice SATA 6 Gb/s cables are certified to provide maximum speeds from your SATA system, up to 6 Gb/s when used with equivalent devices and controllers. One end of this internal cable features a straight connector, while the other end uses a 90-degree connector, which can make for better cable management in some situations,.

Connectors: 3 IDE 40-Pin Female for 2 IDE Drives. The Ultra ATA/ 66 and Ultra ATA/100 Cable, is a 40-pin, 80-conductor cable. This cable is backwards compatible, it works with Ultra ATA/100, Ultra ATA/66, Ultra ATA/33 and DMA, and with EIDE/IDE hard drives & CD-ROM drives.

Combo SATA (Serial ATA) and PATA(IDE) PCI RAID Controller Card.

Brand new, sealed.

Support Following M.2 (NGFF) PCI-e ACHI SSD ST-NGFF2013 M2 M-Key SSD as 2013-2014-2015 MACBOOK SSD for Air A1465 A1466 Pro A1398 A1502. can replace SSD modules from following macbook 2: 2012 version MacBook Air SSD is 7 17 pin, size is 109 mm 24 mm.2012 version MacBook Pro SSD is 7 17 pin, size is 89 mm 33 mm.It's SATA interface.

High quality SATA to SATA extension data cable. SATA to SATA Cable x 5. Cable length: 50cm.

The Serial ATA standard provides for the adoption of a new 15-pin drive power connector, replacing the ubiquitous 4-pin Molex connector. However, existing system cases and power supplies may have an insufficient number of SATA power connectors, while still retaining the older Molex connectors. This 24" adapter cable plugs into a 4-pin Molex power plug and provides four 15-pin SATA power connectors. Each SATA power connector is spaced about 6 inches apart, allowing four drives to be easily daisy chained to the single power line. The power wires are contained within a net jacket to keep them neat and tidy within the system case. Warning! The Molex connector provides only 5 and 12 VDC power. While many SATA drives only require these power levels, some require the additional 3.3 VDC power.

CablesOnline Part Number: FF-018. 2x 34-Pin (keyed) Card Edge Female IDC Connectors. The 34-Pin conductor cable uses the Card Edge to connect your drive. 5.25" Drive Ribbon Cable.

For 2012 macbook pro air ssd to SATA adapter. Fit only the following models of Apple 2012 MACBOOK PRO A1398 MC975 MC976 SSD Fit only the following models of Apple MACBOOK AIR MD224 MD223 MD231 MD232 SSD.

This 18" SATA data cable connects a SATA drive to the motherboard of your PC or server. Compatible with SATA I / II / III. Connectors: straight, L-shaped. Color: Red. Servers & Workstations.

This SCSI Adapter features a DB25 male connector on one side and a Centronics CN50 SCSI-I female connector on the other side. Ideal for converting from DB25 to CN50. CN50 Female Connector. CablesOnline Part Number: AD-S01.

Covered by full Supermicro manufacturer warranty ! Hours of Operation.

A1465 2012 - MacBook Air "Core i5" 1.7 11" (Mid-2012) MacBook Air "Core i7" 2.0 11" (Mid-2012). Install SSD CArd in this adapter as SATA HDD. A1466 2012 - MacBook Air "Core i5" 1.8 13" (Mid-2012) MacBook Air "Core i7" 2.0 13" (Mid-2012).

Converts Secure Digital Card into IDE compatible hard drives. 1x SD to 3.5"IDE adapter. You can install the OS onto the SD Card. No hard disk noise from your workstation. Support PIO, Multi-Word DMA and Ultra DMA data transfer mode.

Connect one IDE Device to a 40-Pin Plug Connection. 2 Female 40-Pin Connectors.

Connect one 40-Pin IDE Device to a 40-Pin Plug Connection. (2) Female 40-Pin Connectors.

3ft SCSI-3 (HPDB68) to SCSI-3 (HPDB68) External 68-Pin Male/Male Cable. (2) HPDB68 HD68 68-pin Male Screw Type Connectors. Connectors are half pitch 68 position male on both ends. Length: 3ft. Double shielded cable provides maximum protection against data corrupting EMI/RFI.

This SATA cables enables you to extend a SATA interface.

Thunderbolt to thunderbolt cable Male to male for new Macbook. Thunderbolt cable can also be use a new iMac as a display for a MacBook Pro equipped with Thunderbolt. Use the Thunderbolt cable to connect your Thunderbolt-equipped peripherals to your new iMac or new MacBook Pro.