The cover fit almost perfectly except for two fasteners on the back of my mounting base that were not drilled on the shroud. This was a simple fix with my trusty drill. I also placed a few 1/4" washers at these connections to accommodate a 1/4" space between the shroud hole and the base hole to avoid misalignment of the bottom edge of the shroud. The factory holes on the shroud were not exact but close enough so a little angle on the screw was sufficient to get them in place. There are many similar after market products to pick from that may or may not fit well. I suggest measuring the shroud to be replaced and choose the closest match to length, height, width and general shape. This should maximize your chance of a successful replacement.
Verified purchase: Yes | Condition: New
It does look great. Better than my old one. But only a few of the holes matched. I have 14 all together, and this only had 12. The 2 in the back we're not there. So I made them myself. And only 1 in the front matched. The other wouldn't even go in the hole. And I was able to get 3 in on each side. So the trick I did, was get in a only 1 on the sides, then keep lifting and looking/measuring, & marked with a pencil where it should be. Some of the holes that are pre-made on the sides, let u see where u need to be, so I just needed to adjust them slightly. But again, the back didn't have any. So I had to lift and look. If all the screws are in on the sides, then u can't lift. So that's why it's easier to only have a few in. Closer to the front of course, Otherwise the back won't lift. Also, it does not come with screws, so don't throw away the old ones. Read full review
Verified purchase: Yes | Condition: New
This shroud is a little thinner than my OEM Dometic one. But is much more flexible probably due to the age and sun exposure to the old shroud. Had to drill a couple of extra holes in the front and grind out a few more holes to match the A/C base. Not difficult at all took about 30 minutes to remove old, modify new and install. If it stays flexible for several years it should be the last one I have to buy.
Verified purchase: Yes | Condition: New
I was worried about fit but this fit my air conditioner perfect. The quality appeared to be the same as the original equipment. My original cover had the back side next to the radiator open, and this one had the plastic that wrapped all the way around which I think is a better, stronger design than the original.
Verified purchase: Yes | Condition: New
Although the rear of the shroud is vented, which is a nice feature, it concaves toward the aluminum AC cooling fins…which could touch and bend those fins. As sure I’m going to reinforce the bottom rear of shroud so it will be straight instead of concave
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Other RV, Trailer & Camper Parts & Accessories
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Other RV, Trailer & Camper Parts & Accessories