500W Wind Turbine Grid Tie Power Inverter AC 90V-130V Dump Load Controller 12VDC

We also have another THREE 500W Wind Power Grid Tie Inverter Versions, please check it.

You are bidding on a Brand New

500W Small Grid Tie Power Inverter

(with built-in Dump load controller, but not with dump load)
for

Wind Turbine Generator Energy System

Works great for wind Turbines with DC output of 500 watts and under....if you need 500 watts of wind inverter or AC input, please search it at our store.

If you need solar power grid tie inverters, please search it at our store or contact me as you do not need the wind starter kit

Feature:

1. This 500W micro grid tie inverter is designed specially for small wind energy system.

2. This inverter can directly connect wind charger through inverter to home grid.

3. This inverter has been built in dump load controller, it can maintain the rotating speed of the wind turbine and keep the voltage from the wind turbine always at the range of the rated range of the grid tie inverter. It also has a high voltage protection function, when the wind is too strong, and the dump load controlling system can not keep the output voltage from the wind turbine, the controller will disconnect itself from the wind turbine, so it is very safe to be used.

4. Easy to installation, just need wind turbine, grid tie inverter, then directly can put into home grid

Note: this inverter only has grid tie inverter function, do not have traditional inverter function, please do not connect the battery for 12v dc source, for further questions, please feel free to contact us.

Features MPPT (Maximum Power Point Tracking) allowing each Wind turbine to run at optimum output. 

 Specifications:

Mechanical Specifications:

Operation Procedures:

The small type grid tie power inverter can obtain the wind energy from wind generators and can tie to the grid through its output cable with no extra equipment. the installation is very convenient and reliable.

The system which combines the small grid tie power inverter and the wind generator is konw as "SGTS".

The inverter can be connected to any outlet at home, as long as this line is run by the conventional electric network. The small grid tie monitors the volume, frequency and phase of the home grid, then product a pure sune wave that the frequency and phase are as same as the grid's.

1, Connect Wind Turbine’s DC supply cables to the DC input terminal of the inverter, be sure that the polarity is correct. Recommended DC input cable size for maximum output is 8AWG or cables that can handle more than 30A . Optimal length would be less than 8m , longer cables will experience higher voltage drop. The range of output power of wind generator is 20W~500W.

2,  Connect the supplied AC power cord to the inverter and plug it to a home wall socket.

3, The 3 green LED indicators will start to cycle from left to right when the grid and DC supply is detected. This indicates the inverter is operating under normal condition. The rate of the cycling is according to how much power is being output from the solar panels or the wind turbine. The more big output power is, the more fast the rate is. If there is no AC grid detected, the red LED will be on, the inverter will not put out power, this is called “Island Protection”.