Futaba 6EX 2.4GHz Air R617FS 4-S3004 FUTK6901 

    This is the Futaba 6EX Transmitter with the 2.4GHz FASST system,
        R617FS 6-ch Receiver and four S3004 Ball Bearing Servos.

Full Range System-Ideal For All Types of R/C Aircraft Including Park Flyers.

FEATURES

• Futaba's FASST (Futaba Advanced Spread Spectrum Technology) shifts very quickly virtually eliminating signal conficts and interruptions unlike other 2.4GHz systems that only stay on one or two frequencies
• R617FS high sensitivity receiver weighs only 0.25oz (7g) without case yet is a full range system for all aircraft from giant scale to Park Flyer applications-no need to buy separate receiver for specific aircraft rubber grommets installed where antennas exit to eliminate stress and fraying of the wires
• Dual antenna diversity enables FASST system to automatically and seamlessly select the best reception between the two antennas built into the receiver ensuring that the aircraft stays under constant control of transmitter regardless of altitude
• Pre-Vision Packet Screening technology scans incoming data for potential problems and applies sophisticated error correction techniques for solid impenetrable link with model
• Easy Link system features a unique ID code in the transmitter that links to the receiver insuring that receiver only follows commands from this transmitter-with over 134 million possible codes there is no chance for a conflict
• No hassle Fail Safe programmed through transmitter-no complicated set-up steps or binding plugs
• When performing a ground check, the Power Down function allows modeler to reduce power from up to 50+ paces away-like retracting the antenna on a conventional transmitter
• Purpose built custom IC chips for key functions; no off-the-shelf IC chips
• One year limited warranty

        Standard Programming Features:
          Trainer function-transmitter can be master or student, compatible
            with other Futaba systems
          Six model memory
          Servo reversing
          End point adjustment
          Airplane or heli programming
          Dual Rate /Exponential for ailerons, rudder and elevator
          Fail Safe-safety throttle setting in case of transmitter signal
            loss
          Battery Fail Safe-safety throttle setting in case of signal loss
          Stick Mode-Choose from Mode 1-Mode-4
          Changeable Throttle Stick-ratchet for airplanes or smooth for helis
          Adjustable Stick Length

        Airplane Features;
          Programmable Mixing (1 & 2) any two channels can be combined
          Pre-Programmed Throttle Cut for safely shutting off engine
          Wing mixing for flaperon, flap trim, V-tail and elevon

        Helicopter Functions;
          Three swashplate types
          Five-Point Normal and Idle Up Throttle/Pitch Curves
          Revo, Gyro and Swash to Throttle mixing
          Swash AFR Adjustable Function Rate for use w/ 3S or 3E swash types

INCLUDES

• Futaba 6EX Transmitter
• NT8F600B 9.6V 600mAh Transmitter Battery, FUTM1440
• FBC-19B(4) 120V AC Battery Charger, FUTM1830
• Four S3004 Ball Bearing Servos, FUTM0004
• R617FS Receiver, FUTL7627
• Receiver Battery: NR-4J 600mAh, FUTM1280
• Switch Harness-J Style Connector SWH13 FUTM4370
• Neck Strap

SPECS

• Transmitter; Power Supply: 9.6V Current Drain: 170mA

        Receiver;
          Size: 1.6 x 1.1 x 0.35" (40 x 27 x 9mm)
          Power Requirement: 4.8 - 6V
          Current Drain: 80mA (at no signal)
          Weight: 0.35oz (10g) with case
                  0.25oz  (7g) without case

        Servo;
          Speed:   .23 sec/60° @ 4.8V
                   .19 sec/60° @ 6.0V
          Torque:  44 oz-in (3.2 kg-cm) at 4.8V
                   57 oz-in (4.1 kg-cm) at 6.0V
          Length: 1.6" (41mm)
          Width:   .8" (20mm)
          Height: 1.4" (36mm)
          Weight: 1.3 ounce (37.2 grams)
        Connector: "J" type with approx. 5" wire

Part FUTK6901 by Futaba