RED KIT House of Kolor KD3004 DTS Epoxy Surfacer Sealer

SUBSTRATE:
• OEM Finishes
• Bare Steel
• Bare Aluminum
• Bare Fiberglass
• Galvanized Surfacers
• Various Plastics (Testing For Adhesion Is Recommended)
• Body Fillers

COMPONENTS:
KD3000 series of primers were designed to be intermixed with each other to tint the primer closest to the base coat color being
applied. This is important in reducing the number of coats of base coat also in the event the finish is chipped or scratched the damage
area won’t be as obvious. (Refer to mixing chart for formulas)
• KD3000 – Medium Gray
• KD3001 – Black
• KD3002 – White
• KD3003 – Yellow
• KD3004 – Red
• KD3005 – Blue
• KDA3000 – Activator
• RU310 – Fast Reducer
• RU311 – Medium Reducer
• RU312 – Slow Reducer
• RU313 – Very Slow Reducer
• RU300 – Medium Exempt Reducer (1.0 lbs/gal VOC)
• RU301 – Slow Exempt Reducer (1.0 lbs/gal VOC)

MIXING RATIO:
KD3000 Series Kustom DTS Foundation Surfacer/Sealer is a two or three part system.
Aggressively mix the KD3000 Series DTS surfacer/sealer thoroughly before activating or reducing.
Always measure, do not guess.
Stir mixed components well to ensure a thorough cure, use a paint shaker for best results. No incubation time is needed. Shop conditions can vary pot life.

SURFACER(S)
For High-Build (HB):
Mix four (4) parts KD3000 Series DTS surfacer/sealer to one
(1) part KDA3000 Activator. (4:1 by volume)
One Medium Wet Coat Equals Approx. 1.3 mils. Of Film Build.

For Medium-Build (MB):
Mix four (4) parts KD3000 Series DTS surfacer/sealer to one (1) part KDA3000 Activator and reduce with
one (1) part Kosmic Reducer. (4:1:1 by volume) One Medium Wet Coat Equals Approx. 1 Mil. Of Film Build.

SEALER(S)
Refer to section on KD3000 Series DTS Surfacer/Sealer (Applied As A Sealer).
FOR CALIFORNIA (2.1 lbs/gal VOC)
Reduce with RU300 or RU301 Exempt Kosmic Reducers.

POT LIFE
As a surfacer – 45 to 90 minutes (depending on shop conditions)
As a Sealer – Refer to section on KD3000 Series DTS Surfacer/Sealer (Applied As A Sealer).