TELEFLEX 3300 BOAT CONTROL CABLE CC230 FOR YAMAHA, HONDA, SUZUKI OUTBOARDS 12'

 

 

Teleflex 3300 Universal Control Cables are suitable for most applications for I/Os, inboards and outboards.

Fit most engines, including Yamaha, Volvo, Suzuki, Tohatsu, Honda and Nissan 

 

These cables use a stainless steel lubri-core wire for smooth operation and long life.

They have stainless steel core wire/brass fittings with a 10-32 UNF threads. Nominal 3 inch travel. 6 inch minimum bend radius.

CC230 Replaces CC172.

Teleflex Morse Controls
How to Measure Control Cable Length for Installation

For initial installations, measure the distances A and B along an unobstructed path to the throttle and/or clutch connection. Add A and B together then round up to the nearest whole foot. That is the recommended length. Cable bends for most cables should not have less than an 8" radius. Cable bends using Supreme Cables can be as low as 4". Care should be taken to avoid unnecessary cable bends because each bend adds to a cable’s inefficiency and lost motion.

For outboard applications it is necessary to add an additional four (4) feet for the loop that allows unrestricted engine movement.

For replacement cable installations simply remove the cable from the boat and measure the cable as indicated below. That length will be the proper replacement length. Some cables have the length stamped on them 

To order specify the length in inches and round up to the nearest whole foot. Other connection kits or hardware may be necessary.