After 10 years of usage the original Sloan valve in our bathroom stopped flushing properly. I ordered a new valve on EBay, quick shipping, valve was easy to replace. The printed instructions where easy to follow. no special tools required, about 1/2 hour later the toilet is working great. Thanks
Verified purchase: Yes | Condition: New
I rated every question a no, only to get your attention and find out what is the problem with my flush. I would like to have attached photos, but there is no way to attach them. I have purchased two new ones, and seem to continuously have the same problem . I follow the instructions on installing , turning until the water stops. It works fine for a while, then the water will not stop. I pull the unit out and find that the bottom sealing ring has pulled off. Question is why? Very frustrating! Please help. Am I doing something wrong?
Verified purchase: Yes | Condition: New
It fixed the water leak after like 15 years of usage. Make sure to use sliocone grease at the bottom O ring to prevent water leak in the future. I highly recommend using a shower head to rinse the inside of the water tank to remove any debris. The factory instruction of opening the water for 3p seconds will not remove the old debris at the bottom after many years. The debris will cause water leak in the future. Follow the instruction to insert the cartridge by counter clock, do clock wise turn until it is 2 line below the tank, turn on the water line and turn the cartridge 1/4 turn at a time to avoid over tighten the cartridge, wait 30 seconds to check if the tank pressurized. You can hear the water start filling up the tank by the change of the sound. The water line filter probably does not need to be replaced. I also recommend using the wrench for this and a 22mm socket to remove and install it, it will be a lot easier as the cartridge requires a lot of torque to remove.Read full review
Verified purchase: Yes | Condition: New
good replacement for my 9 year old valve that broke at the plunger end and was leaking at the seals. easy to install with good instructions. I hope this one lasts or outlasts the one it replaced.
Verified purchase: Yes | Condition: New
This product is the authentic valve from Sloan to fix your Flushmate when the old one wears out, as mine did after nine years of use. It's easier to install than it looks, and the instructions on how to do so and how to adjust it are thorough. Follow them! I'm as pleased with the result as when my Flushmate toilet was brand new.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Toilet Parts & Attachments
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Toilet Parts & Attachments