LOWER 48 USA SALES ONLY PLEASE!
Quality custom-made signal generator test lead with Amphenol (screw-on) type connector that fits Heathkit, Eico, Tripolett, Hickok, B&K, PACO, Precision, and other signal generators that utilize this hard to find connector. THIS SIGNAL GENERATOR LEAD HAS THE FOLLOWING ADVANTAGES:
1. Made of quality copper shielded highly flexible genuine rubber covered cable.
2. Has built-in termination to prevent standing waves and so generator meter will read correctly should your generator have a metered output.
3. Has built-in "dummy antenna" so that you do not have to fumble around with extra capacitors, resistors, etc. when you perform radio alignments.
4. Has built-in isolation to protect your signal generator in case you connect the leads to the wrong place in the radio.
5. High quality genuine Mueller micro clips for secure connections to your radio.
6. Copper woven "litz wire" ground lead for excellent RF conductivity.
7. I make these cables by hand and sweep test each and every cable so that I maintain 100%
quality control which ensures you will receive a quality cable you can depend on.
Try pricing just the amphenol connector and the Mueller clips and realize what a good deal this is!!
I guarantee that this cable is FAR superior to the factory cable that came with your generator.
Check out the old professor's feedback - I have sold over 60 of these to satisfied customers.
Paypal only. ---- SATISFACTION OR YOUR MONEY BACK!!!!!!! Paypal confirmed addresses only and I do not ship to APO boxes. Thanks.