5 PACK OF SOLAR SUN RINGS
FREE EXPEDITED SHIPPING VIA USPS PRIORITY MAIL!
I Have 100% Positive Feedback--Buy With Confidence!
What Are Solar Sun Rings
The Solar Sun Ring is a passive solar swimming pool heating device made from two sheets of heavyweight U.V. resistant vinyl. The upper clear layer holds insulating air and focuses sunlight on the blue colored lower layer.
The blue layer absorbs about 50% of the sunlight and converts it to heat. The balance of the sunlight is allowed to pass through for deep water heating.
How Do Solar Sun Rings Work?
At night the contained air acts as an insulating blanket to retain heat gained during daylight. Solar Sun Rings are equipped with six magnets to improve clarity and decrease hardness of the water in your pool. The magnets are positioned to facilitate rafting. The strength of the magnets will permit single position removal but will easily separate to prevent entrapment in accidental falls.
Solar Sun Rings were designed to be compatible with automatic pool cleaners. In the event the suction hose catches on a ring, the ring will separate from the raft to allow the pool cleaner to continue. Neither water nor pool chemicals can evaporate through the Solar Sun Rings two layers of heavyweight vinyl. You will save water and chemicals about equal to the percentage of the surface covered. Once the water in your pool has reached adequate temperature, Solar Sun Rings may be turned over to conserve water by limiting evaporation without significantly heating the water.
How Many Solar Sun Rings Do I Need?
We recommend enough Solar Sun Rings be purchased to cover 70% to 80% of your pools surface, ignoring the small triangles between the rings.
INSTRUCTIONS FOR USE
PROPER INFLATION IS NECESSARY TO USE THIS PRODUCT INFLATION
The inner grid should be inflated orally with about two large breaths of air for an average person. Do not use more air, two breaths is all that is needed. Close the valve. Bunch up the SSR and move the contained air around to separate both layers of plastic. The SSR cannot be made to lie flat unless the layers are separated. The SSR should be about the size of a soccer ball when bunched up.
Inflate the outer ring orally until it is firm. Close the valve. Place each SSR single layer in direct sunlight on a flat non-abrasive surface until the packing lines relax. This should take from 30 minutes to 3 hours depending on the intensity of the sun. If the SSR does not lie flat after the packing lines are relaxed, examine the SSR for areas not separated. If the SSR still does not lie flat measure the diameter. A properly inflated SSR is 59 inches or 149.86cm in diameter. If the SSR is smaller use the deflation tube provided to let air out of the inner grid until it lies flat. Excessive air in the grid section, deep packing lines and failure to separate both layers of plastic will all cause the outer edge to curl and distort.
HOW TO USE THE SOLAR SUN RINGS
HEATING: Once the Solar Sun Rings are inflated, cover up to 70% to 80% of the surface of your pool with Solar Sun Rings by placing the blue colored side on the water. You should not cover more than 70% of the surface on deep pools and not more than 80% on shallow pools. For the best solar effect, keep the upper surface of the Solar Sun Rings clean and clear.
COOLING: Turn the Solar Sun Rings over so the blue side is up. The Solar Sun Rings do not heat water efficiently when upside down.
WATER AND CHEMICAL SAVING: Neither water nor chemicals can evaporate through the two layers of heavyweight vinyl. You will save on water and chemicals about equal to the actual percentage of water covered.
CARE OF SOLAR SUN RINGS
CARE: Once inflated proper care of this product will greatly extend its useful life. Pool decking is designed to be abrasive to prevent slips and falls. Do not walk on Solar Sun Rings or drag Solar Sun Rings on this abrasive surface. When Solar Sun Rings are not on the pool water do not stack them in direct sunlight, excessive
Absolutely NO heating costs involved!
Solar sun rings will provide your pool with 21,000 BTU's of heat per solar ring per day.
Pool solar sun rings are passive solar heating devices.
These inflatable, 60 inch-diameter rings should cover 70% to 80% of your pool's surface.
Tested at the National Pool Industry Research Center at Cal Poly University for proven results.
Solar sun rings are great for use in all chlorine and salt water system swimming pools.
Do not overinflate.
Solar sun rings feature six magnets each so rings attach to each other easily.
Pool solar sun rings are compatible with automatic pool cleaners.
Allow you to open your pool earlier and close it later each swimming season.
Constructed from two sheets of heavyweight, UV-resistant vinyl for great durability.
Environmentally friendly, green option for pool heating.
Easier to handle than solar pool blankets.
Easy to install and easy to remove.
|Pool Size ||Number of Solar Sun Rings |
|12' Round ||3 |
|15' Round ||5 |
|18' Round ||7 |
|21' Round ||9 |
|24' Round ||10 |
|28' Round ||14 |
|16'x32' Oval/Rectangle ||10 |
|18'x36' Oval/Rectangle ||14 |
|20'x40' Oval/Rectangle ||14 |