Powered by Frooition Pro
Motorcycle Cat Eye LED Brake Tail light Integrated with turn signals Harley KTM
The listing is for one Brand new 12 Volt 1.0/0.5w Custom Taillight with clear lens
It can be used as taillight and brake light, and integrated with turn signals.
The kit includes including hardware, black rubber fender gasket for protecting your paint, and a chrome license plate mount.
It has total 13 LED bulbs in each light, and addtional three white LEDs to illuminate the license plate.
Approx size for each light: 2.5"(length)x1.5" (width) x 1.5" (thickness) (both lights will be lit up when it is wired on the bike, in the picture only one light is lit up for illustration purpose)
It will fit all motorcycle with conventional rear fender, or old sportbikes
Note: Not DOT approved, do you use if DOT is required. It has emark.
Each side has four wires:
ground = black
tail light = green
brake light = red
left turn signal = yellow
right turn signal = orange
Note: the slots (measurement is provided in the picture) for license plate may not be wider enough for your license plate, buyer needs to drill holes on the license plate during installation.
No installation instruction
Warning: If you are replacing your standard bulb with LED light, load resistor is required to bring the flash rate down to normal.
You may also like:
Frooition www.frooition.com | eBay design, eBay store design, eBay shop design, eBay template design, eBay listing design
This listing is currently undergoing maintenance, we apologise for any inconvenience caused.