MAF/MAP Sensor Enhancer - HHO Hydrogen Generator 

Map or Maf controller

A MAP/MAF Sensor Enhancer is a must have for anyone installing a Hydrogen Generator on most vehicles as you will not see the gains in miles per gallon until you install a MAP/MAF Sensor Enhancer. In fact, sometimes your vehicle will use more fuel than it did before you installed the Hydrogen Generator.
This is because the oxygen sensor is detecting too much oxygen in the exhaust system after the Hydrogen Generator was installed because of the cleaner burning hydrogen fuel. As a result the oxygen sensor tells the computer to add more fuel to the engine causing even lower miles per gallon.
After installing a hydrogen generator to your vehicle, you need a way of communicating with the computer on your vehicle, and telling it that the engine no longer requires as much fuel as it did before. Your vehicle won't do that on it's own. Installing the HHO Enhancer will allow you to do that.

 With the HHO Enhancer you control the signal that goes from your MAP or MAF sensor to your vehicles computer, allowing your car to use less of the regular fuel and more of the hydrogen gas that has been created from the hydrogen generator.

You may have noticed that my enhancer has only one knob. Many people are selling enhancers with 2 knobs, a switch, and maybe LED's.   Most time I ‘m not using second switch or second knob. The switch puts the reading to the second knob. One knob is supposed to be for city driving and the other for highway.  I found that I could usually leave my sensor alone when switching from city to highway driving. I do however need to adjust the knob according to the weather. While driving I pay attention to how my car idles and runs. If I have too much of power, or a high idle, I dial the knob a little down.

You need add a safety feature (main switch) which allows you to turn off your HHO Generator when set to factory mode.

 End result - MORE MILES PER GALLON from your vehicle! 

-Option to toggle between enhanced (Economy) mode

or your vehicle’s original (Power) factory mode

 -Each unit is tested prior to shipping 

-Small 3 inch x 1.5 inch x 0.75 inch box

-Installation with label included                         
                         

  This unit will not work if your vehicle uses a MAF sensor that uses a frequency signal to the vehicle computer. Check your vehicle before ordering to see what type MAF sensor you have.

If you're unsure about your sensor, do a internet search or call your local parts store. They should be able to answer your question. You can also call a dealership and ask for the "parts division" They will surely be able to tell you. Do to the nature of these devices I can not offer refunds so please check your application before you make your purchase.