1 REMOVE COVER PLATE

LOOSEN SCREWS ON SIDES AND BOTTOM OF PLATE

REMOVE SCREWS ON TOP OF PLATE

PULL PLATE GENTLY BACK AND UP

2 REMOVE PUSHROD ASSEMBLY

LIFT CREASER CHAIN AND REMOVE PUSHROD

3 REMOVE CABLE DRUM SHAFT

LOOSEN SET SCREW ON CABLE DRUM

PULL OUT DRIVE DOG ASSEMBLY/CABLE DRUM SHAFT

(IF DIFFICULT TAP WITH A SMALL PUNCH AT PUSHROD REMOVAL SIDE)

4 REMOVE CABLE DRUM

KEEPING HORIZONTAL, LIFT DRUM OUT THROUGH HEAD CASTING

(WILL BE A TIGHT FIT AS NEEDED TO PREVENT LEAKS AT BUSHINGS)

5 REMOVE CABLE

LOOSEN RETAINING SCREW PARTLY COVERING SLOT ON THE DRUM

USING A PICK REMOVE THE BEAD OF THE CABLE FROM THE DRUM BY PUSHING UPWARD

REMOVE CABLE

6 REMOVE RETAINING RING AT BOTTOM OF TOOL

REMOVE SCREWS AND REMOVE RING

7 PUSH PLUNGER AND CABLE THROUGH BOTTOM OF TOOL

USE A LONG ROD, WATER PRESSURE OR GENTLE TAPPING ON FLOOR TO MOVE PLUNGER AND CABLE THROUGH BOTTOM OF TOOL

8 REMOVE NUT FROM PLUNGER

REMOVE THE NUT CONNECTING THE CABLE TO REMOVE THE CABLE FROM THE SLOTTED BOLT

9 REPLACE CABLE

WHEN REPLACING NUT ON PLUNGER MAKE SURE THE INNER ROUNDED SIDE OF THE NUT IS FACING DOWN AND THE SLOT IN BOLT IS ALIGNED WITH THE CASTLE NUT 

(THIS SHOULD NOT HAVE BEEN TOUCHED SO YOU PROBABLY DONT NEED TO WORRY)

10 REPLACE IN REVERSE

ANY QUESTIONS ON ALL OF YOUR TAPING TOOL NEEDS- FEEL FREE TO ASK